Смазка Агринол Графитол предназначена для смазывания высокотемпературных узлов трения и скольжения, таких как: подшипники, горячие вентиляторы, петли и замки дверей сушильных камер и других индустриальных механизмов.Смазка предназначена для использования в диапазоне температур от минус 25°С до 180°С.
Гарантийный срок хранения – 5 лет со дня изготовления.
Наименование показателя
Агринол Графитол
Внешний вид
Однородная мазь без посторонних включений черного цвета
Температура каплепадения, °С, не ниже
250
Пенетрация при 25°С, мм·10−1
265–295
Предел прочности при 20°С, Па, не менее
30
Вязкость эффективная при 0°С и среднем градиенте скорости деформации 10 с−1, Па·с, не более
Универсальные тугоплавкие смазки Консталин-1 и Консталин-2 применяются для смазки узлов трения вентиляторов литейных машин, доменных и цементных печей, подшипников качения на железнодорожном транспорте.
Смазки работоспособны в диапазоне температур от минус 20°С до 110°С.
Гарантийный срок хранения – 5 лет со дня изготовления.
Таблица 61
Наименование показателя
Консталин-1
Консталин-2
Внешний вид
Однородная мазь без комков от светло-желтого до темно-коричневого цвета
ТУ У 23.2-30802090-014-2002 Agrinol 1-13 is a universal anti-friction sodium calcium lubricant. The lubricant is utilized for greasing rolling and sliding friction units of machines and mechanisms working at the temperature from minus 20°С up to 110°С. The lubricant remains efficient in rather powerful mechanisms at the temperature to minus 40°С.The lubricant can be delivered to friction units with the help of superchargers as well as by the method of laying. Guarantee period of storage - 5 years from the day of manufacture.
Index Name
Agrinol 1-13
Appearance
Homogenous ointment from light-yellow to dark-brown colour
Temperature of drop falling, °С, not lower than
125
Penetration at 25°С, mm·10−1
180–260
Proof strength at 80°С, Pа
100–400
Efficient viscosity at 0°С and at the average gradient of the strain rate of 10 s−1, Pа·s, not more than
500
Colloid stability, % of the secreted oil, not more than
All-Union State Standards 3333-80 Graphite Lubricant is intended for greasing hard, heavily loaded mechanisms including open gear-boxes, screw joints, guide screws, jacks, springs etc. The lubricant is efficient at the temperature varying from minus 20°С up to 60°С. The exploitation of the lubricant for springs and other analogous mechanisms at the temperature lower than minus 20°С is permitted. Guarantee period of storage - 5 years from the day of manufacture.
Index Name
Graphite Lubricant
Appearance
Homogenous ointment from dark-brown to black colour
Temperature of drop falling, °С, not lower than
77
Penetration at 25°С, mm·10−1, not less than
2501)
Proof strength at 0°С, Pа, not less than
1002)
Efficient viscosity at 0°С and at the average gradient of the strain rate of 10 s−1, Pа·s, not more than
1002)
Colloid stability, % of the secreted oil, not more than
51)
Water fraction of total mass, %, not more than
3
Corrosive influence on metals
Withstands
1) The index is defined only if the lubricant is going to be exported
2) The index is calculated before the stuff is added by the manufacturer
All-Union State Standards 1033-79 The water-proof hydrated calcium lubricant Fatty Solidol is intended for greasing rolling and sliding friction units of various machines and mechanisms functioning at the temperature from minus 25°С up to 65°С. The lubricant is used efficiently in such rather powerful mechanisms as bearings, joints, blocks etc. at the temperature to minus 50°С.The lubricant is utilized for filling in disassembled friction units working at the temperature from minus 50°С up to 65°С as well as for filling in friction units with the help of manual grease superchargers at the temperature to minus 20°С. Guarantee period of storage - 5 years from the day of manufacture.
Index Name
Fatty Solidol
Appearance
Homogenous ointment without balls from light-yellow to dark-brown colour
Temperature of drop falling, °С, not lower than
78
Penetration at 25°С, mm·10−1
230–2901)
Proof strength at 50°С, Pа, not less than
196
Efficient viscosity at 0°С and at the average gradient of the strain rate of 10 s−1, Pа·s, not more than
250
Fraction of total mass, not more than:
-mechanical impurities, not dissolved in HCI, %
None
-water, %
2,5
-free alkali re-calculated into NaOH, %
0,2
-free organic acids, mg КОN/g
None
Fraction of total mass of calcium soaps of fat acids comprising a part of natural fats, %, not less than
11,0
1) The index is defined only if the lubricant is going to be exported
