|
There are no translations available
ТУ У 23.2-30802090-126:2009
Агринол КМ-22 предназначено для изготовления изоляционных пропиточных составов силовых кабелей напряжением 1-35 кВ с бумажной пропитанной изоляцией.
Потребителями масла являются предприятия энергетической отрасли промышленности.
| Наименование показателя |
Агринол КМ-22 |
| Вязкость кинематическая при 100°С, мм²/с, не менее |
22,0 |
| Кислотное число, мг КОН/г, не более |
0,03 |
Температура, °С:
· вспышки в открытом тигле, не ниже
· застывания, не выше |
2700
−10 |
Массовая доля, %, не более:
· механических примесей
· золы
· воды |
Отсутствие
0,007
Следы |
| Коксуемость, %, не более |
0,6 |
| Электрическая прочность при (25 ± 10) °С и частоте переменного тока 50 Гц, Мв/м, не менее |
15 |
Удельное объемное сопротивление при 100°С и напряжении не менее 100 В, Ом·м, не менее:
· на месте изготовления
· на месте потребления |
2,0*1010
1,5*1010 | |
|
ALL-UNION STATE STANDARD 5546-86
HA-30 oil is intended for greasing of compressors of refrigeration machines running on ammonia or carbonic acid.
HF 12-16 Oil is intended for greasing of compressors of refrigeration machines running on freon.
| Index name |
HА-30 |
HF 12 – 16 |
| Meets classifications ISO (DIN 51503) |
46 (KA) |
22 (KC) |
Kinematic viscosity, mm² / s:
at 20 °С, not less than
at 50 °С, not less than |
120 – 150
28 – 32 |
–
Not less than 17 |
| Acid number, mg КОН / g, not more than |
0,05 |
0,02 |
Temperature, °С:
flash point in an open crucible, not lower than
pour point, not higher than
flocculation oil mixture with Freon, not higher than |
185
– 38
– |
174
– 42
– 50 |
Stability against oxidation:
sediment, %, not more than
acid number, mg КОН / g, not more than |
0,02
0,5 |
0,005
0,04 |
| Ash, %, not more than |
0,004 |
– |
| Corrosive influence on metals |
Withstands |
Fraction of total mass, %, not more than:
mechanical impurities
water
water-soluble acids and alkalis |
None
None
None |
|
|
Agrinol KM-22
TS U 23.2-30802090-126:2009
Agrinol KM-22 is intended for manufacturing of insulating impregnating compositions of voltage power cables 1 – 35 kV with a paper soaked insulation. Oil consumers are enterprises of energetic industry.
| Index name |
Agrinol КМ-22 |
| Kinematic viscosity at 100 °С, mm² / s, not less than |
22,0 |
| Acid number, mg КОН / g, not more than |
0,03 |
Temperature, °С:
flash point in an open crucible, not lower than
pour point, not higher than |
2700
– 10 |
Fraction of total mass, %, not more than:
mechanical impurities
ash
water |
None
0,007
Traces |
| Coking ability, %, not more than |
0,6 |
Insulating strength at (25 ± 10) °С and alternating current
frequency 50 Hz, MV / m, not less than |
15 |
Volume resistivity at 100 °С and voltage not less than 100 V, Ohm·m, not less than:
at the place of manufacturing
at the place of consumption |
2,0·1010
1,5·1010 | |
|
AGRINOL MGD-14m
TS U 23.2-30802090-035:2005
Agrinol MGD-14m Oil is used for gas-engine compressors. The oil is used for greasing of motors and compressor parts of such types of gas-engine-compressors as 8GK, 8GKM, 10 GKM, 10GKN as well as similar units running on natural gas.
| Index name |
Agrinol MGD-14m |
| Kinematic viscosity at 100 °С, mm² / s |
13,5 – 15,5 |
| Viscosity index, not less than |
90 |
Temperature, °С:
flash point in an open crucible, not less than
pour point, not less than |
215
– 15 |
Fraction of total mass, %, not more than:
mechanical impurities
water
sulfate zone |
0,015
Traces
0,2 |
| Total alkaline number, mg КОН / g, not less than |
2 |
| Corrosive influence on metals |
withstands |
Stability against oxidation:
sediment against oxidation, %, not more than
acid number against oxidation, mg КОН / g, not more than |
0,2
0,5 |
| Stability according to IPO within 35 h, viscosity increase at 100 °С, %, not more than |
60 |
Tribological characteristics on Four-ball machine at (20 ± 5) °С, N, not less than
scuff index, N, not less than
critical loading, N, not less than
welding loading, N, not less than |
300
784
1568 |
|
|
|
AGRINOL KS-19p
TS U 23.2-30802090-017-2003
Oil for compressor units. The oil is intended for greasing of piston and rotary compressors of average and high pressure.
КS-19
All-Union State Standard 9243-75
Compressor oil of selective refinement KS-19 is intended for greasing of piston and rotary compressors as well as blast-engines.
Compressor Oils K-12 and K-19
All-Union State Standard 1861-73
Compressor Oils K-12 and K-19 are produced from low-sulfur crude oils and are used for lubricating piston and rotary compressors and blowers.
| Index name |
Agrinol
КS-19p |
KS-19 |
К-12 |
К-19 |
Meets classifications ISO VG
ISO 6743 (DIN 51524) |
220
DAB (VDL) |
220
DAA (VB) |
100 / 150
DAA (VC) |
220
DAA (VC) |
| Kinematic viscosity at 100 °С, mm² / s |
18 – 24 |
18 – 22 |
11 – 14 |
17 – 21 |
| Viscosity index, not less than |
90 |
92 |
– |
| Acid number, мg КОН / g, not more than |
0,03 |
0,02 |
0,15 |
0,04 |
Тemperature, °С:
flash point in an open crucible, not lower than
pour point, not higher than |
240
– 15 |
260
– 15 |
216
– 25 |
245
– 5 |
Fraction of total mass, %, not more than:
mechanical impurities
water |
None
Traces |
None
None |
0,007
None |
| Coking ability, %, not more than |
– |
0,5 |
0,3 |
0,5 |
Stability against oxidation:
sediment, %, not more than
acid number, mg КОН / g, not more than |
None
0,5 |
None
0,5 |
0,25
– |
0,015
– |
| Corrosive influence on metals |
Withstands |
– |
Withstands |
| Corrodibility on lead plates, g / m², not more than |
– |
10 |
– |
|
|
|
