Hydraulic Oils
|
There are no translations available
ТУ У 23.2-30802090-107:2008
Жидкости для амортизаторов Агринол МГП-10 и Агринол МГП-12 применяются в качестве рабочих жидкостей в телескопических стойках и гидравлических амортизаторах грузовых и легковых автомобилей.
Температурный диапазон применения жидкости Агринол МГП-10 от -50°С до 100°С, а жидкости Агринол МГП-12 от -40°С до 100°С.
Гарантийный срок хранения – 2 года со дня изготовления.
|
Наименование показателя |
Агринол
МГП-10 |
Агринол
МГП-12 |
|
Вязкость кинематическая, мм²/с: |
|
|
|
при 100°С, не менее |
– |
3,8 |
|
при 50°С, не менее |
10,0 |
12,0 |
|
при минус 20°С, не более |
1000,0 |
800,0 |
|
Индекс вязкости, не менее |
– |
85 |
|
Кислотное число, мг КОН/г, не более |
0,15 |
– |
|
Температура, °С: |
|
|
|
вспышки в открытом тигле, не ниже |
145 |
140 |
|
застывания, не выше |
−50 |
−40 |
|
Массовая доля, %, не более: |
|
|
механических примесей |
Отсутствие |
|
воды |
Отсутствие |
|
Массовая доля цинка, %, не менее: |
– |
0,03 |
|
Цвет, единицы ЦНТ, не более |
– |
6,0 |
|
Коррозионное воздействие на металлы |
Выдерживает |
|
Склонность к пенообразованию, см³, не более: |
|
|
|
последовательность I |
– |
50 |
|
последовательность II |
– |
50 |
|
последовательность III |
– |
50 |
|
Стабильност пены, см³, не более: |
|
|
|
последовательность I |
– |
5 |
|
последовательность II |
– |
5 |
|
последовательность III |
– |
5 |
|
Трибологические характеристики на ЧШМ при температуре (20±5)°С: |
|
|
|
показатель износа при нагрузке 196 Н, мм, не более |
– |
0,55 |
|
Зольность, %, не более |
– |
0,5 |
|
Плотность при 20°С, кг/м³, не более |
– |
917 |
|
|
All-Union State Standards 6794-75АМG-10 Oil serves as a working liquid for hydraulic devices.Guarantee period of storage – 10 years from the day of manufacture for moderate and northern zones of the climatic belt and 5 years from the day of manufacture for the southern zone of the climatic belt.Table 19 | Index Name | АМG-10 | | Appearance | Transparent, homogenous liquid of red colour | | Kinematic viscosity, mm²/s: | | | - at 50°С, not less than | 10 | | - at minus 50°С, not more than | 1250 | | Acid number, mg KON/g , not more than | 0,03 | | Temperature, °С: | | | - initial boiling temperature, not lower than | 210 | | - flash temperature in an open crucible, not lower than | 93 | | - solidification temperature, not higher than | −70 | | Fraction of total mass, %, not more than: | | | - water | None | | - mechanical impurities | 0,003 | | - water-soluble acids and alkalis | None | | Active elements’ fraction of total mass, %, not less than: | | | - calcium | 0,28 | | - zinc | 0,045 | | - phosphorous | 0,040 | | Corrosive influence on metals | Withstands | | Thermal-oxidative stability and corrosive activity at 125°С: | | | during 100 h: | | | - kinematic viscosity after oxidation at 50°С, mm²/s, not less than | 9,5 | | - acid number after oxidation, mg KON/g, not more than | 0,15 | | - weight index of corrosion, mg/cm² | ±0,1 | | during 50 h: | | | - kinematic viscosity after oxidation, mm²/s | | | at 50°С, not less than | 9,8 | | at minus 50°С, not more than | 1500 | | - acid number after oxidation, mg KON/g, not more than | 0,08 | | - weight index of corrosion, mg/cm² | ±0,1 | | Tribological characteristics at (20±5)°С: | | | - deterioration index at loading of 196 N, mm, not more than | 0,6 | | Density at 20°С, kg/m³, not more than | 850 |
|
|
|
ТУ У 23.2-30802090-060:2006 Gidroil NМ-46 Oil is utilized as a working liquid for hydraulic drives, hydrotransmissions and circulating oil systems of diverse units, machines and mechanisms of industrial equipment. Guarantee period of storage – 3 years from the day of manufacture.
Index Name | Gidroil NM-46 | Kinematic viscosity, mm²/s: |
| - at 40°С | 44–50 | - at 100°С | 6–8 | Viscosity index, not less than | 100 | Acid number, mg KON/g | 0,5–0,7 | Temperature, °С: |
| - flash temperature in an open crucible, not lower than | 190 | - solidification temperature, not higher than | −28 | Colour, units of CNT, not more than: |
| - without attenuation | 3,5 | - with attenuation 15:85 | 1,0 | Ash level, %, not more than | 0,2 | Fraction of total mass, %, not more than: |
| - water | None | - mechanical impurities | None | Inclination for foaming, сm³, not more than: |
| - at 24°С | 20 | - at 94°С | 30 | - at 24°С after the test at 94°С | 20 | Tribological characteristics: |
| - scuff index, N, not less than | 400 | - critical loading, N, not less than | 921 | - welding loading, N, not less than | 1470 | - deterioration index at 20°С and at loading of 392 N, mm, not more than | 0,4 | Density at 20°С, kg/m³, not more than | 900 |
|
|
|
ТУ У 23.2-30802090-067:2006
The year-round hydraulic oil Agrinol VMGZ is used as a winter oil. It also can be utilized as а year-round working liquid in hydraulic drives and hydraulic control systems of constructing, road, logging, lifting and other machines and mechanisms exploited in the open air at the working temperature of oil from minus 55°С up to 80°С in the North.
Guarantee period of storage – 5 years from the day of manufacture. Index Name | Agrinol VMGZ | Kinematic viscosity, mm²/s: |
| - at 50°С, not less than | 10 | - at minus 40°С, not more than | 1500 | Viscosity index, not less than | 140 | Temperature, °С: |
| - flash temperature in an open crucible, not lower than | 135 | - solidification temperature, not higher than | −60 | Fraction of total mass, %, not more than: |
| - mechanical impurities | None | - water | None | Active elements’ fraction of total mass, %, not less than |
| - zinc | 0,01 | Colour, units of CNT, not more than | 1,0 | Corrosive influence on metals | Withstands | Ash level, %, not more than | 0,2 | Inclination for foaming at 24°С, сm³, not more than | 200 | Stability against oxidation: |
| - sediment fraction of total mass after oxidation, %, not more than | 0,05 | Changing of weight of the UIM-1 rubber, % | 4–7,5 | Acid number, mg KON/g | 0,40–1,0 | Density at 20°С, kg/m³, not more than | 870 |
|
|
|
ТУ У 23.2-30802090-047:2005 Agrinol А Oil is intended for the year-round exploitation in fluid convertors, automatic gears at ambient temperature to minus 35°С. The oil serves as a winter oil for hydrostatic drives of self-propelled agricultural and other machines. Agrinol R Oil is utilized in systems of steering-wheel hydrointensification as well as in hydrovolumetric gears. Guarantee period of storage - 5 years from the day of manufacture.
Index Name | Agrinol А | Agrinol R | Appearance | Liquid from yellow to dark-brown colour | Kinematic viscosity, mm²/s |
|
| - at 40°С | 30–45 | 17–22 | - at 100°С | Not less than 6,5 | Not more than 5,0 | Viscosity index, not less than | 90 | 90 | Temperature, °С: |
|
| - flash temperature in an open crucible, not lower than | 175 | 163 | - solidification temperature, not higher than | −40 | −45 | Fraction of total mass, %, not more than: |
| - mechanical impurities | 0,01 | - water | None | - water-soluble acids and alkalis | None | Active elements’ fraction of total mass, %, not less than: |
|
| - calcium | 0,16 | 0,16 | - zinc | 0,08 | 0,08 | Corrosive influence on metals | Withstands | Inclination for foaming, cm3, not more than: |
|
| - at 24°С | 150 | 150 | - at 94°С | 150 | 150 | - at 24°С after the test at 94°С | 150 | 150 | Stability in the DK-NAMI device: | |
| - sediment after diluting the oil with the solvent, %, not more than | 0,07 | 0,03 | Ash level, %, not less than | 0,60 | 0,60 | Changing of mass of the UIM-1 rubber in the oil, %, not more than | +5 | +5 | Density at 20°С, kg/m³, not more than | 900 | 900 |
|
|
| |
|
